Sterling Rotisserie components. Replacement Rotisserie components for Sterling grills. FREE shipping.

Use the dimensions of your old parts, preferably after removal, to compare to what we show below. Comparing dimensions is the best way to insure you get the right parts for your Sterling grill.

Sterling Rotisserie components

ROTISSERIE SHIELD BRACKET FOR RIGHT SIDE WITH TWO MOUNTING HOLES for some Sterling grills. (Also, a replacement for 10184-E43.)

Part Number: 10184-E33
Weight: .20

Image not available

$6.40

ROTISSERIE MOTOR BRACKET for some Sterling grills.

Part Number: 10184-E42
Weight: .25

$8.17

ROTISSERIE SHIELD BRACKET FOR RIGHT SIDE WITH TWO MOUNTING HOLES for some Sterling grills.

Part Number: 10184-E43
Weight: .20

$5.85

ROTISSERIE SHIELD BRACKET FOR LEFT SIDE WITH ONE MOUTNING HOLE for some Sterling grills.

Part Number: 10184-E44
Weight: .20

$6.72

Universal Heavy Duty Rotisserie Kit for some Sterling grills.

Motor with on/off switch.
Heavy duty forks.
Counter balance kit.
33 1/2” Spit rod.
6” Spit rod extension.
Other rotiss components

Part Number: 60090
Dimensions: 33 1/2
Weight: 5.01

$100.60

Plastic spit rod handle with brass insert for some Sterling grills.

Requires bushing BU-1 (5/16” square spit rods) or BU-2 (3/8” square spit rods)
Will fit our spit rods: SR-5; SR-8; SR-43
Requires a threaded end on the spit rod
The mounting hole in the handle is 3/8-16 coarse thread female

Part Number: PH-1
Weight: 0.2

$6.70

Universal rotisserie kit for some Sterling grills. THIS KIT INCLUDES AN INVERTED MOTOR BRACKET THAT POSITIONS THE MOTOR INVERTED. Includes:

R06 stainless steel motor
SR-5 31” X 5/16” spit rod
BU-1 spit rod bushing
PH-1 spit rod handle
MH-1B Chrome-plated meat forks
MB-3B Inverted motor mounting bracket and screws
MB-2B Rotisserie bushing bracket (for grills with no bushing notch in casting)
Maximum 25 lbs. balanced load

Fits grills with hoods up to 26 inches wide. Be sure to measure before ordering.

Note: The pre-drilled mounting holes in the MB-3B rotisserie motor mounting bracket are designed to accommodate existing hole patterns approximately 1 3/8” apart. It is possible that you may have to drill new holes.

NOTE: This kit does NOT include spit counter balance, which should be used to insure even weight distribution.

NOTE: Some of the parts in the kit are designed for a 5/16” rod. Rod SR-43, which is a 3/8” square rod, will not work with some of the parts in this kit.

Part Number: RK-MHP
Weight: 4.6

$112.84

Universal durable battery operated rotisserie motor for some Sterling grills. Conveniently eliminates the need for electric cords. Runs on 2 D cells (not included).

Part Number: RO-4
Weight: 1.0